Hisun HS400 - Brake System

CHASSIS
5-14
Brake system
The Brake system is crucial to the life
safety of the operator and passengers
therefore, it must be periodically inspected
and maintained. This vehicle uses the
double return route hydraulic pressure disc
brake system. Please follow the tips of
inspection as below.
1 Check the amount of Brake Fluid in the
reservoir. If it is lower than the
minimum mark, refill the reservoir with
the same type of fluid as was
recommended by the manufacturer, to
ensure to fluid level is higher than the
minimum mark (1).
2 The brake pedal should be kept
between 20mm-30mm, Otherwise,
please adjust the screw to meet
required travel distance.
3 Inspect the brake pedal feel. If it feels
spongy the brakes will need to be bled
and fluid in the reservoir filled.
Must use DOT4 Brake Fluid
4 Periodical inspection of the wear
condition of rear brake disc is also
necessary. The brake disc must be
replaced depending on its wear
condition. Inspect for warpage (1) and
disc thickness (2).
5 Disk brakes use hydraulic pressure of
brake fluid. Therefore, brake lines must
be periodically inspected and replaced.
Inspection method: If the brake line
has aging, cracks or distortion, you
must replace it.