Hisun HS400 - Brake Pads

Maintenance and Adjustment
3-18
2. Lift up the hood.
3. Check that the brake fluid level is above
the minimum line on the brake fluid
reservoir (1).
Warning:
Use Only DOT 4 Brake fluid otherwise, the
rubber seals may deteriorate, causing
leaks and poor brake performance.
Note:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
4. Close the hood.
CHECKING THE FRONT BRAKE PADS
1. Remove the front wheels.
2. Inspect the brake pads for wear.
Look at the wear indicator grooves (1).
If needed replace the brake pads as a
set.
Brake pad wear limit (a)
1.5 mm (0.06 in)
3. Operate the brake pedal.
4. Install the front wheels.
CHECKING THE REAR BRAKE
PADS
Follow the same procedure as the front
brake Pads. Look at the wear indicator
grooves (2).
Brake pad wear limit (a)
1.5 mm (0.06 in)
Warning:
Whenever any service has been
performed on the brake calipers or
Pads make sure to pump up the
brakes before driving the vehicle.