Hisun HS400 Service Manual

Maintenance and Adjustment
3-11
•
Squeeze the excess solvent out of
the element and let it dry.
Note:
Do not twist or wring out the element.
This could damage the foam material.
• Apply engine oil onto the filter
element, the squeeze out the
excess oil.
Note:
The element should be wet but not
dripping.
6. Install the air filter element and the
air filter case cover.
Note:
To prevent air leaks make sure that the
sealing surface of the element matches
the sealing surface of the case.
7. Lower the cargo bed.
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Lift the hood up.
3. Remove the radiator cap and check
the fluid level in the radiator with the
vehicle cold.
4. Fill the radiator to the top with fresh
antifreeze 50/50 and install the
radiator cap.
5. Check the antifreeze level in the
coolant reservoir and fill to between
the maximum (3) and minimum (2)
lelvel indicators.
6. Start the engine and allow the
vehicle to warm up.
7. Shut off the vehicle and recheck the
coolant level in the reservoir.
CHANGING THE COOLANT
1. Lift up the hood.
2. Remove the reservoir cap (4)
(above).
3. Disconnect the coolant reservoir
hose (1), and drain the reservoir
into a suitable container.
4. Connect the reservoir hose.
5. Remove the coolant drain bolt (1)
(below) along with the copper
washer on the water pump.

Hisun HS400 Specifications

General

Brand	Hisun
Model	HS400
Category	Offroad Vehicle
Language	English