Hisun HS400 - Page 93

Maintenance and Adjustment
3-27
ADJUSTING THE HEADLIGHT BEAM
1. Turn the headlight beam adjuster (1) in
or out.
CHANGING THE HEADLIGHT BULB
1. Lift up the hood
2. Pull back the headlight holder cover (2)
3. Remove the headlight bulb holder (with
bulb) (3) and remove the bulb by
unhooking the headlight bulb holder
tabs.
4. Install a new headlight bulb into
the holder.
Note:
Avoid touching the glass part of the
bulb. Keep it free from oil;
otherwise, the transparency of the
glass, life of the bulb, and luminous
flux will be adversely affected. If oil
gets on the bulb, thoroughly clean it
with a cloth moistened with alcohol
or lacquer thinner.
5. Pull the headlight bulb holder
cover back into place.
6. Close the hood.
CHANGING THE TAIL/BRAKE LIGHT
BULB
1. Pull back the bulb holder
cover
2. Remove the bulb holder
with bulb
3. Remove the bulb.
4. Install a new bulb
Be careful not to touch
the glass part of the new
bulb when installing.
5. Install the bulb holder
and pull the bulb holder
cover back into place.