Hiwin D2 User Manual

D2 Drive User Guide v1.8 1. About the User Guide
HIWIN Mikrosystem Corp. 5
 Usage instructions
Warning

Do not touch the terminal or inside part when it is powered to
avoid electric shock.

Do not touch the terminal or inside within 10 minutes from the
power off. The residual voltage may cause electric shock.

Do not change the wiring when it is powered to avoid electric
shock.

Do not cut the cable, apply too much stress to it, or place heavy
objects on it. Laying the cable between objects may cause fire or
electric shock.
Attention

Do not install the product in the place exposed to moisture or
erosion, or in an environment containing ignitable gas. Do not
use the product close to any flammable objects.
 Storage
Prohibited

Do not store the product in the place exposed to water, moisture,
direct sunlight, harmful gas, or liquids.
 Handling
Attention

Be careful of handling the product and avoid damaging it.

Use appropriate handling methods and do not apply too much
pressure to the case.

The product shall not be stacked too high to avoid collapsing.
 Installation location
Required

Do not install the product in the place exposed to high
temperatures, high humidity or flying dust, iron powder, or
cutting powder.

Install the product in the place where the ambient temperature
meets the specification of User Guide. Use one cooling fan if the
temperature is potentially high.

Do not install the product in the place exposed to direct sunlight.

Since the product does not have one waterproof or
moisture-proof case, do not use it outdoors or install it in the
place where water or other liquid exists.

Install the product in the place with the low vibration.

When the motor continues moving, the heat is generated due to
the use frequency. Use one cooling fan, or set to standby status
when the motor stops. So that, the ambient temperature of motor
does not exceed its specific value.

Hiwin D2 Specifications

General

Brand	Hiwin
Model	D2
Category	DC Drives
Language	English