D2 Drive User Guide v1.8 1. About the User Guide
HIWIN Mikrosystem Corp. 3
Risks specifically identified:
Warning
At installing or exchanging motor power
cables, if the correct sequence of
connection is not followed, the motor may
run abnormally. It is possible to cause injury
to persons or damage to equipment. Please
use correctly labelled cables.
Warning
Each motor model has its own rated
maximum payload. If applying more than
such payload to the motor, it may cause
abnormal motion, damage to equipment,
or injury to persons.
Warning
If users select to use own made motor
encoder cables, please check the User
Guide carefully or contact our service
department. The wrong connection of such
cable may cause abnormal motion or injury
to persons.
Warning
During the usage of motor, in case of the
careless removal of encoder connector
from the drive, please do not hot plug it
back to the drive. It may cause abnormal
motion, damage to equipment, or injury
to persons.
Warning
Applying the open type of optical feedback
system (e.g. optical scale), please note that
if the scale is stained or scratched, it may
cause abnormal motion, damage to the
motor or equipment, or injury to persons.
Warning
When the motor is regularly under the
operation, and careless touch or collision
to the encoder connector on the drive, it
is recommended to power cycle the
drive, or it may cause abnormal motion,
damage to equipment, or injury to
persons.
Warning
Applying the open type of magnetic
feedback system (e.g. magnetic scale),
please note that if the strong magnetic
object comes close to the scale, it may
cause abnormal motion, damage to the
motor or equipment, or injury to persons.
Warning
During the usage of motor, please do not
unplug the encoder connector when it is
not powered off, move the motor, and
then plug it back to the drive, or it may
cause abnormal motion, damage to
equipment, or injury to persons.
To Next Page
Loading...
Need help?
General
