Technical Specification 73
Doc: HMSI-27-309, Rev. 3.11Anybus Communicator PROFINET User Manual
B.4 Regulatory Compliance
EMC Compliance (CE)
This product is in accordance with the EMC directive 89/336/EEC, with amendments 92/31/EEC and
93/68/EEC through conformance with the following standards:
• EN 50082-2 (1993)
EN 55011 (1990) Class A
• EN 61000-6-2 (1999)
EN 61000-4-3 (1996) 10 V/m
EN 61000-4-6 (1996) 10 V/m (all ports)
EN 61000-4-2 (1995) ±8 kV air discharge, ±4 kV contact discharge
EN 61000-4-4 (1995) ±2 kV power port, ±1 kV other ports
EN 61000-4-5 (1995) ±0.5 kV power ports (DM/CM), ±1 kV signal ports
UL/c-UL Compliance
IND: CONT. EQ.
FOR HAZ LOC.
CL I, DIV 2
GP A,B,C,D
TEMP
CODE
E203225
WARNING - EXPLOSION HAZARD - SUBSTITUTION OF ANY COMPONENTS
MAY IMPAIR SUITABILITY FOR CLASS I, DIVISION 2.
WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS,
TURN OFF POWER BEFORE REPLACING OR WIRING MODULES.
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO
BE NON-HAZARDOUS.
ATTENTION – RISQUE D’EXPLOSION – LE REMPLACEMENT DE TOUT
COMPOSANTS INVALIDE LA CERTIFICATION CLASS I, DIVISION 2.
ATTENTION – RISQUE D’EXPLOSION – EN ZONE EXPLOSIVE, VEUILLEZ
COUPER L’ALIMENTATION ÉLECTRIQUE AVANT LE REMPLACEMENT OU LE
RACCORDEMENT DES MODULES.
ATTENTION – RISQUE D’EXPLOSION – NE PAS DÉCONNECTER
L’ÉQUIPEMENT TANT QUE L’ALIMENTATION EST TOUJOURS PRÉSENTE OU
QUE LE PRODUIT EST TOUJOURS EN ZONE EXPLOSIVE ACTIVE.
To Next Page
Loading...
