SAFETY
U.C10.00.00.EN Version 2.0 17
is a risk of dangerous situations and possible damage to the
machine!
DANGER!
Make sure the load bearing capacity of the ground is
adequate; use access mats or outrigger pads. Caution: never
on manholes or beside/in holes.
DANGER!
It is prohibited to use the compact crane to transport or lift
persons.
DANGER!
It is prohibited to use the compact crane to pull loads free,
cause them to fall, push them or pull them at an angle.
DANGER!
It is prohibited to bypass a sensor; doing so can cause danger
to life and damage to the machine. Contact Hoeflon
International B.V. immediately in the event of a defective
sensor.
DANGER!
It is prohibited to change the pressure settings and the
motor/engine speed; this can lead to dangerous situations and
damage to the machine and immediately voids the warranty.
DANGER!
Never lift heavier loads than the maximum permitted working
load according to the table.
DANGER!
Never leave the compact crane unattended with a load
hanging from the machine.
DANGER!
Only move loads that can move freely from the surface they
are sitting on and that are located directly beneath the hook!
DANGER!
Remove the keys from the ignition switch when operating the
crane; prevent unauthorised persons from switching the
machine on or off.
DANGER!
Do not raise the boom more than 60° if the outrigger legs on
the ballast side are positioned parallel (180°) to the compact
crane! Otherwise the compact crane may tip over.
DANGER!
It is prohibited to raise the jib beyond 70°.
DANGER!
Never place materials or tools on the engine shroud of the
machine or on the crane. These parts can be knocked off by
the engine or fall off of the machine.
DANGER!
It is prohibited to use the compact crane in stormy weather
and/or in wind speeds in excess of Beaufort Force 6.
WARNING!
Only suitable, trained persons who are familiar with the
content of this user manual and have completed the user
training provided by Hoeflon International B.V. may operate or
work with the compact crane!
WARNING!
Dangerous situations can arise in which there is intense
interaction between the machine, the operator, the load, the
To Next Page
Loading...