HOEFLON C10 - Setting Track Width; Transport Position

WORKING WITH THE COMPACT CRANE
U.C10.00.00.EN Version 2.0 37
6.4.2 Setting track width
WARNING!
Make sure the compact crane is standing on the outriggers so that the
crawler tracks are able to move freely.
WARNING!
Avoid contact with the outrigger legs due to risk of entrapment!
 First raise the crane on the outriggers.
 Press button to set the crawler tracks wider or button to set the crawler tracks narrower (see
figure 14).
 Only set the crawler tracks to the maximum or minimum width.
6.4.3 Transport position
The compact crane must be put in the transport position for driving. To do this, follow these steps:
 Be careful when lowering the boom to the transport position that the boom and jib do not contact the
engine shroud and toolbox at the front and that the jib does not contact the toolbox if the jib is hanging
beside the boom.
 The jib adapter can be attached to the jib if the jib is hanging beside the boom and other attachments are
desired.
 Secure attachments in the intended locations during transport: 30° section and winch head beside the
boom, manual jib extension on the right side of the column, jib adapter in the boom.
 Make sure that in the transport position the winch is always rolled up and the attachments are stowed and
secured.