ThinPrep
®
Integrated Imager Operator’s Manual
3.11
USER INTERFACE
Lab name
Figure 3-16 Lab Name Button
To enter or edit a name for the facility at which the Integrated Imager is located, press the
Lab Name
button. Press the letter buttons to enter a name, up to 20 characters long. See
Figure 3-17. To create a
capital letter, press the
Shift
button and then press the letter. With the next letter, the system reverts
to lowercase. Use the
Space
button for a space and the
Delete
button to remove entered letters.
Press the
Switch Keys
button to display a keypad screen to enter numbers. Switch between
keyboard and keypad as often as desired before saving changes.
Figure 3-17 Edit Lab Name Keyboard and Keypad Screens
Keyboard Display
Shift
for a capital letter
Delete
to remove entries
Switch Keys
to display keypad
Cancel
to return to System Settings screen.
Reverts to previous entry (if any)
Continue
to save the entry and return to Sys-
tem Settings screen
Keypad Display
Type in numbers
Delete
to remove entries
Switch Keys
to display keyboard
Cancel
to return to System Settings screen.
Reverts to previous entry (if any)
Continue
to save the entry and return to Sys-
tem Settings screen
To Next Page
Loading...
