3-12
14) Remove the four 6 x 25 mm flange bolts and the four 6 mm
washers, and remove the silencer duct assembly.
15) Attach the wrench to the 16 x 49 mm washer bolt on the
crankshaft pulley as shown.
Turn the crankshaft pulley clockwise.
16) Align the cutout in the crankshaft pulley with the “ ” mark
on the chain case.
• Do not turn the crankshaft pulley counterclockwise.
6 x 25 (4)
[1]
6 mm
WASHER (4)
[2]
SILENCER DUCT
ASSEMBLY
[3]
CRANKSHAFT
PULLEY
[3]
CRANKSHAFT
PULLEY
[2] 16 x 49 mm
WASHER BOLT
[1]
WRENCH
[4]
CUTOUT
[5] CHAIN
CASE
[6]
“” MARK
To Next Page
