Honda BF135A - Oil Case

14-96
5) Apply the engine oil to the threads and seat of the sixteen
10 x 40 mm flange bolts.
Install the two dowel pins and the oil case on the mount
case, then loosely tighten the sixteen 10 x 40 mm flange
bolts.
6) Apply engine oil to the new 11.5 x 3.5 mm O-ring, and
install it on the oil level pipe.
7) Install the oil level pipe on the mount case and tighten the
6 x 12 mm flange bolts.
Install the oil level gauge.
8) Tighten the 10 x 40 mm flange bolts to the specified torque
in the numbered sequence in two or three steps.
TORQUE: 34 N
.
m (3.5 kgf
.
m, 25 lbf
.
ft)
9) Tighten the 12 mm drain plug washer and the oil drain plug
bolt on the oil case. Tighten them to the specified torque
and add the engine oil.
TORQUE: 23 N
.
m (2.3 kgf
.
m, 17 lbf
.
ft)
10) Install the following parts.
– Extension case/lower rubber mount (P. 14-91)
– Gear case assembly (P. 14-5 and 44)
– L./R. engine under cover (P. 4-14)
– Engine cover (P. 4-2)
[5]
OIL CASE
10 x 40 (16)
[4]
6 x 10 mm
DOWEL PIN (2)
[2]
OIL LEVEL GAUGE
[1]
OIL LEVEL PIPE
[3]
11.5 x 3.5 mm
O-RING
6 x 12
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬
⑭
⑮
⑯