14-95
b. INSTALLATION
1) Clean the oil case and mount case mating surfaces and the
both sides of the oil pan gasket with a cleaning solvent and
a shop towel.
2) Apply bead [ø1.0 – 5.0 mm (ø0.04 – 0.20 in)] of the liquid
gasket (ThreeBond
®
#1211 or equivalent) to the indicated
area of the oil pan gasket.
• Assemble within 90 minutes after application of the liquid
gasket. If the parts have been left unassembled for 90
minutes, remove the old gasket and apply a new gasket
again.
• Do not fill in the oil case with the engine oil for 15 minutes
after assembly.
NOTICE
3) Apply engine oil to the circumference of the new 20.6 x 2.6
mm O-ring, and install it on the oil strainer.
4) Install the oil pan gasket on the mount case. Install the oil
strainer and tighten the two 6 x 18 mm flange bolts.
[2]
OIL PAN GASKET
[4]
OIL PAN GASKE
[3]
LIQUID GASKET
(Apply to both sides.)
[1]
Liquid gasket
application area
[3]
OIL STRAINER
[4]
OIL PAN GASKET
[2]
20.6 x 2.6 mm
O-RING
[1]
MOUNT CASE
6 x 8 (2)
To Next Page
