Honda BF135A - Page 150

4-31
3) Install the under cover front bracket securely with the two
8 x 30 mm hex. bolts and the two 8 mm washers.
4) Pass the tube and the wires through the hole in the under
cover front bracket.
5) Connect the trim angle sensor 3P connector and the power
tilt motor 2P connector. Install the power tilt motor 2P
connector on the lower side of the connector bracket A and
the trim angle sensor 3P connector on the upper side of the
connector bracket A.
[3]
CONNECTOR
BRACKET A
[1]
TRIM ANGLE SENSOR
3P CONNECTOR
[2]
POWER TILT
MOTOR
2P CONNECTOR
[1]
UNDER
COVER
FRONT
BRACKET
[4] HOLE
[5]
UNDERCASE
GROMMET C
[2] WIRES
[3] TUBE
[1]
UNDER COVER
FRONT BRACKET
[2]
8 mm WASHER (2)
[3]
8 x 30 mm
HEX. BOLT (2)