Honda BF135A - Page 280

BF135A•BF150A
5-127
14) Connect the fuel pump 2P connector and set the connector
on the connector bracket.
15) Install the harness band clip on the connector bracket in the
position shown in the drawing.
16) Secure the cover lock cable and the fuel hose with the
clamps.
17) After assembly, check each fuel tube and clamp and check
that they are not interfering with the neighboring parts.
18) Turn the ignition switch ON. Check that the fuel pump turns
for 2 seconds and that there is no fuel/water leakage.
[1]
HARNESS
BAND CLIP
[5] COVER LOCK CABLE
[6]
FUEL TUBE
[3]
FUEL PUMP 2P
CONNECTOR
[2]
CLAMPS
[1]
PRESSURE REGULA-
TOR RETURN HOSE
[4]
CONNECTOR
BRACKET
[4]
FUEL TUBE B
[3] WATER TUBE
[2]
FUEL HOSE
(HIGH PRESSURE
SIDE)