7-4
9) Remove the following bolts and washers from the underside of the mounting case.
•8 x 100 mm flange bolt (1)
• 10 x 80 mm flange bolt (1)
• 10 x 110 mm flange bolts (2)
• 12 x 70 mm hex. bolt (1)
• 12 x 130 mm hex. bolts (2)
• 12 mm washers (3)
10) Lift up the engine assembly slowly and remove it from the mounting case.
[2]
10 x 16 mm
DOWEL PIN
[1]
ENGINE ASSEMBLY
[7]
14 x 20 mm
DOWEL PIN
[9]
MOUNTING
CASE GASKET
[3]
EXHAUST GUIDE
GASKET
[8]
OIL PUMP RUBBER
8 x 100
10 x 80
10 x 110 (2)
[6]
12 x 70 mm
HEX. BOLT
[5]
12 x 130 mm
HEX. BOLT (2)
[4]
12 mm WASHER (3)
• Be sure that the hoist hooks are set on the three engine
hangers securely.
• Lift up the engine assembly while holding the engine
vertically.
NOTICE
11) Remove the two dowel pins, mounting case gasket, exhaust guide gasket and the oil pump rubber.
To Next Page
