9-13
8) Pushing the cam chain tensioner arm toward the cam
chain, install the cam chain tensioner by aligning the
cutouts of the cam chain tensioner with the recess in the
cam chain tensioner arm. Tighten the two 6 x 30 mm flange
bolts to the specified torque.
TORQUE: 12 N
.
m (1.2 kgf
.
m, 9 lbf
.
ft)
Remove the 1.5 mm pin.
9) Wipe up oil, etc. from the crankshaft outer surface with a
clean shop towel.
Install the crankshaft pulser plate on the crankshaft with the
“OUT-SIDE” mark facing out.
[3] CRANKSHAFT
(Wipe up oil, etc. from crankshaft
surface with a clean shop towel.)
[1]
“OUT-SIDE” MARK
[2]
CRANK PULSER
PLATE
[5]
CUTOUTS
[4]
RECESS
[3]
CAM CHAIN
TENSIONER
ARM
[2]
CAM CHAIN
TENSIONER
6 x 30 (2)
[1] 1.5 mm PIN
To Next Page
