Honda BF135A - Page 540

14-73
d. ASSEMBLY
1) Apply gear oil to the circumference of the new bearing.
2) Place a wood block under the reverse bevel gear.
3) Install the bearing on the reverse bevel gear using the
special tool and the hydraulic press.
TOOL:
Oil seal driver, 65 mm 07JAD-PL90100
or 07JAD-PL9A100
4) Soak the gear case in the container filled with oil with the
bearing installation side toward down.
5) Heat the oil to 80 – 90˚C (176 – 194˚F).
6) After the entire of the bearing installation side of the gear
case becomes hot, remove the gear case from the
container and install the bevel gear shim and the reverse
bevel gear/bearing assembly on the gear case quickly.
• Do not heat the oil above 90˚C (194˚F).
• The entire gear case becomes hot. Be sure to wear the
gloves during the operation.
• Do not apply the force of 8,829 N (900 kgf, 1984 lbf) or
above during installation.
NOTICE
[1]
OIL SEAL DRIVER,
65 mm
07JAD-PL90100 or
07JAD-PL9A100
[2]
50 x 90 x 20 mm
RADIAL BALL
BEARING
[4]
REVERSE BEVEL
GEAR
[3]
WOOD BLOCK
[6]
GEAR CASE
[1]
THEMOMETER
[3]
Heat the oil to 80 – 90˚C
(176 – 194˚F).
[5]
REVERSE BEVEL
GEAR/BEARING
ASSEMBLY
[4]
REVERSE BEVEL
GEAR SHIM
[2]
GEAR CASE