Performance Series Indoor Day/Night H.264 IP Camera User Guide
Document 800-09312V2 Rev A 33
08/2012
2. Open the Honeywell IP Utility InstallShield Wizard.
Method 1: DVD
Insert the DVD into the DVD-ROM drive.
Note If InstallShield does not open automatically, navigate to [DVD
drive]\Honeywell IP Utility\Honeywell IP Utility Setup.exe. Double-click on
the file to launch the program.
Method 2: Web site
a. Navigate to
www.honeywellsystems.com/support/download-center/index.html.
b. Follow the instructions on the page to log on, and find your camera.
Note You will need a Username and Password to log in to the Download Center. To
receive a Username and Password, contact the customer service center for
your region. Contact information is found on the Download Center page.
c. Under Honeywell IP Utility, download, extract and open the Honeywell IP Utility
Set-up.exe icon from where you extracted the file.
3. When the Honeywell IP Utility InstallShield Wizard opens, follow the instructions.
After the installation is complete, a Honeywell IP Utility icon displays on the
desktop.
Accessing the Performance Series Installation Guides
1. To access the installation documents that were installed with the IP Utility, click Start
All Programs Honeywell Video Systems Performance Series Manuals.
2. Select the applicable PDF to open and view.
Installing the Honeywell IP Utility Software with Windows 7
Before installing the Honeywell IP Utility on a computer that runs on Windows 7, you should
confirm that the following conditions have been met:
Enable Microsoft .NET Framework 3.5 on Your Workstation
Although Microsoft .NET Framework 3.5 is pre-installed on Windows 7, you might have to
confirm that it is also enabled on your workstation.
1. Go to Start Control Panel Programs Programs and Features.
To Next Page
Loading...
Need help?
General