52
IP Camera Web Client
Configuring IP and Firmware Settings
Depending on the hardware installation, there is a tab called either Device Information or
Device Settings. In both cases, the IP and Firmware Settings panel mirrors the information
available in the Honeywell IP Utility. It provides read-only network settings, firmware
settings, and video formats without having to access the IP Utility.
The Device Settings are the same for the Primary and Secondary streams.
Figure 4-6 IP and Firmware Settings: Device Information Tab
Resetting the Device
When resetting the device, you can choose from: Restart, Restore, and Reset to Defaults.
See Figure 4-6. Each of these functions take approximately 2 minutes to complete, and
during that time, the camera will lose connection to the web client. You will be asked if you
wish to proceed before the action occurs.
Device Name as entered in the
IP Utility program
IP Address on the network
(DHCP/Static/APIPA)
Firmware Settings including
product name and version
Video Format - NTSC or PAL
Subnet Mask and Default Gateway
address that connects the camera to
the network
MAC Address is a factory assigned
address unique for each device
Restart Restarts the camera while maintaining the existing configurations.
Restore Resets the camera to the factory defaults, except the network settings.
Reset to
Defaults
Resets to the camera’s factory defaults.
To Next Page
Loading...
Need help?
General