Performance Series Indoor Day/Night H.264 IP Camera User Guide
Document 800-09312V2 Rev A 49
08/2012
Navigating the Web-Client User Interface
Figure 4-3 Web Client Window Layout: Administrator Log On
The web-client application user interface consists of multiple user-friendly views organized
by function. Access to the views is user-controlled.
The URL corresponds to the IP Address as
configured in the IP Utility.
Click Logout to exit the program.
Confirm the user type logged in.
Each tab has a section for configuration
and/or navigation controls.
Click the tabs
to access the
available
configurations
and settings.
If logged on as a Guest, only the Live
View tab is available. Administrators
can access all tabs.
The image from your
camera displays on
every tab.
SnapShot
Table 4-2 Tabs/Views in the Web-Client Application
Tab Enables you to...
Live View View video and take SnapShots.
Device Settings View the network settings and firmware details of the camera.
Restore to factory defaults and reboot a camera.
Compression
Settings
Configure the compression.
Set the maximum bit rate and/or target bit rate that the camera will
provide across the network based on priority mode settings. This
value is the threshold that you do not want the bit rate to exceed.
View received bit rate and frame rate statistics of the current image
in real time.
Camera Setup Configure auto exposure and white balance for the camera.
Video Analytics Configure the camera sabotage detection settings and view video
display.
IO and Audio Not supported.
To Next Page
Loading...
Need help?
General