To Next Page

To Previous Page

IP Camera Web Client

Video Codec Settings Tab

Figure 4-8 Video Codec Settings Tab Available Functions

Configuring the Compression Settings

1. On the Compression Settings tab, in the Statistics area, select the Received check

box to receive in real time the bit rate and frame rates for the current image.

Deselecting the check box disables the refresh rate.

Note The Received check box is disabled by default. When you log out, this check

box reverts to the disabled state.

2. Use Table 4-4 to set up the streaming resolution and Table 4-5 for the other

compression settings.

Set the Resolution

Set the Frame Rate

Set the Priority for Quality or Bit Rate

Set the Compression Ratio

Set the Target Bit Rate

Primary Stream Secondary Stream

Set the Maximum Bit Rate (kbps)

Set the GOP (Group of Pictures)

Default settings shown for NTSC models

Table 4-3 Video Streaming Resolutions for HD44IP

Primary Stream Resolutions Secondary Stream Resolutions

H.264 H.264 MJPEG

640 x 480 (4:3 aspect ratio)

640 x 360 (16:9 aspect ratio)

320 x 240 (4:3 aspect ratio)

320 x 180 (16:9 aspect ratio)

640 x 480 (4:3 aspect ratio)

640 x 360 (16:9 aspect ratio)

320 x 240 (4:3 aspect ratio)

320 x 180 (16:9 aspect ratio)

640 x 480 (4:3 aspect ratio)

640 x 360 (16:9 aspect ratio)

320 x 240 (4:3 aspect ratio)

320 x 180 (16:9 aspect ratio)

Honeywell HD45IP User Manual

Other manuals for Honeywell HD45IP