800-13897 - A - 01/2013
2
Getting Started 2
This chapter covers:
• Starting and shutting down the HRG DVR
• Rebooting and locking the HRG DVR
• Using the Setup Wizard
• Setting the date and time
Starting and Shutting Down the HRG DVR
Proper startup and shutdown procedures are crucial to maintaining the life of your HRG DVR.
Starting the HRG DVR
Note Ensure that the input voltage meets the requirements of the HRG DVR, and that
the GND is grounded.
Note Ensure that the VGA on the HRG DVR rear panel is connected to a display
device, or that the VIDEO OUT port is connected to a monitor. You cannot view
and navigate the menu without being connected to a monitor.
1. Ensure the power supply is plugged into an electrical outlet. It is HIGHLY recommended
that you use an Uninterruptible Power Supply (UPS) in conjunction with the unit.
2. Press the POWER switch on the rear panel. After the power has been started up, the
POWER indicator on the HRG DVR will light green.
To Next Page
Loading...
Need help?
General