Honeywell HRG4X User Manual

92 | HRG Performance Series DVR User Guide
www.honeywellvideo.com
Menu items include:
• Camera: Select a PTZ camera.
• Call Preset: Call a PTZ preset.
• Call Patrol: Call a PTZ sequence.
• Call Pattern: Call a PTZ pattern.
• Preset Settings: Enter PTZ preset configuration menu.
• Patrol Settings: Enter PTZ sequence configuration menu.
• Pattern Settings: Enter PTZ pattern configuration menu.
• PTZ Menu: Enter PTZ control menu.
• PTZ Settings: Enter PTZ settings menu.
Configuring PTZ Settings
Settings for a PTZ camera must be configured before it is used. Before proceeding, verify that
the PTZ and RS-485 of the DVR are connected properly.
To configure PTZ settings:
1. Click Menu  Settings  PTZ to enter the PTZ Settings menu (see Figure 9-2).
Figure 9-2 PTZ Settings Menu
2. Next to Camera, select the channel where PTZ camera is installed.
3. Set the Baudrate, Data Bit, Stop Bit, Parity, Flow Control, PTZ Protocol, and Address.
4. Click OK to save the settings and exit the menu.
Note All setting parameters (baud rate, data bit, stop bit, parity, flow control, PTZ
protocol and address) must be consistent with the PTZ camera connected.

Honeywell HRG4X Specifications

General

Brand	Honeywell
Model	HRG4X
Category	DVR
Language	English