NCA-2 Manual — P/N 52482:M5 03/20/2019 53
Events Operation
Block Acknowledging
The default settings for all event types, with the exception of fire alarms, is Block Acknowledgment. Fire Alarms are always acknowl-
edged on a point-by-point basis.
Figure 4.30 An Unacknowledged Event
Figure 4.31 An Acknowledged Event
FIRE ALARM
Detector L01D074
Zone Z001 Z001 SMOKE(PHOTO)
10:01:01A TUE JAN 22, 2019 N081L01D074
EVENT COUNTS
FIRE ALARMS:005 PREALARM:000 TROUBLE:002
SUPERVISORY:002 SECURITY:001 OTHER:000
10:44:54A TUE JAN 22, 2019
ACKNOWLEDGE FIRE ALARM SIGNAL SILENCE
MORE INFORMATION SYSTEM RESET
This is the type of
event that occurred.
This is the point address
on which the event
occurred.
This is the time/date
of the event.
This is the
current time/date.
NOTE: When there are no unacknowledged events or if the System is Normal, the ACKNOWLEDGE soft key will not be visible.
NOTE: For detectors, modules and panel circuits connected to the NFS2-3030, custom action messages are displayed for the “MORE
INFORMATION” soft key on the events screen. Other types of points and FACPs display the “READ STATUS” soft key.
ACKNOWLEDGED FIRE ALARM
DETECTOR ADDRESS 32
ZONE 3 Z003 SMOKE(PHOTO)
09:48:35A TUE JAN 22, 2019 N239L01D032
EVENT COUNTS
FIRE ALARMS:0004 PREALARM:0000 TROUBLE:0001
SUPERVISORY:0002 SECURITY:0001 OTHER:0000
09:50:36A TUE JAN 22, 2019
SIGNAL SILENCE
SYSTEM RESET
PROGRAM/ALTER STATUS MAIN MENU
This is the type of event that has
been acknowledged; it includes
some detail about the event.
This is the current
time/date.
To Next Page
Loading...
Need help?
General
