Honeywell ST 800 Series - Power up Diagnostics; PILD Status; Table 26 - Power up Diagnostics

Page 84 ST 800 Series HART/DE Option User’s Manual Revision 5.0
Power Up Diagnostics
Table 26 – Power Up Diagnostics
Pwr fail
counter
Parameter Description Total number of power-ups
experienced by the unit.
Set-up
None – initialized to zero prior to
leaving factory.
NVM
Backup once each 8 hour period
Note
Only one power failure in each 8 hour
period is counted.
Time since
last power fail
Method
Description
Displays time since last power-up in
minutes.
Set-up
None.
NVM
Backup once each 8 hour period–
PILD Status
Name Description
PILD Functionality
Status
PILD Status
For DP transmitters possible statuses are:
• both sides blocked
• one side blocked.
• Not Blocked
For AP/GP transmitters possible statuses are:
• Blocked
•
Not blocked
PILD factor
PILD factor for prediction.
Possible values are 0.0 to 1.00 to the second decimal
places.
Current Mode Current Work Mode
If PILD is enabled, modes are:
• Training
• Monitoring
If PILD is disabled,
no output.