Honeywell ST 800 Series - 9 Troubleshooting and Maintenance; HART Diagnostic Messages; Table 27 - HART Diagnostic Messages

Revision 5.0 ST 800 Series HART/DE Option User’s Manual Page 87
9 Troubleshooting and Maintenance
Table 27 lists both critical and non-critical (warning conditions) diagnostics.
9.1 HART Diagnostic Messages
Table 27 critical and non-critical HART diagnostic messages.
Table 27 – HART Diagnostic Messages
Critical Diagnostics (Failure Conditions) Non-Critical Diagnostics (Warning Conditions)
Electronic Module DAC Failure
No DAC Compensation
Meter Body NVM Corrupt
No Factory Calibration
Config Data Corrupt
PV Out of Range
Electronic Module Diag Failure
Fixed Current Mode
Meter Body Critical Failure
Sensor Over Temperature
Sensor Comm Timeout
Meter Body Excess Correct
Local Display
Low Supply Voltage
No DAC Calibration
Tamper Alarm
Meter Body Unreliable Comm
Loop Current Noise
AO Out of Range
URV Set Err. Span Config Button
LRV Set Err. Zero Config Button
PILD Blockage Detected