Clone Unit
Load Clone
This option loads the application, all unit settings and register values from Removable media to the battery-backed
RAM (Regardless of AutoLoad settings) and then resets the OCS for the settings to take effect.
User needs to perform the following to Load Clone:
Step 1: Select “Clone Unit” from main System Menu of OCS as shown below:
Step 2:Selecting “Clone Unit” menu will open the following menu screen. Select “Load Clone”.
NOTE: For security enabled files, Load clone asks for password validation before loading the application.
Load Clone can also be triggered by setting %SR164.10 bit to “1” from Ladder program or graphics. Once the oper-
ation is completed, this bit is made zero by the firmware. When Load Clone operation is triggered by this SR bit, it
does not ask the user for confirmation for loading clone. The success / failure of the operation is also not notified on
screen to the user.
In case of failure of “Load Clone” operation, %SR164.12 bit is set to “1” by the firmware and never reset.
Page 138 of 163
To Next Page