Auto Term(J)
end
ClearTerm(K)
(Cont'd)
InhSlfT~t<L>
E5c
XferOD
I nhDcT5t(W)
FldSeperetor
Configuring
the
Terminal
Table 2-2. Terminal Configuration Menu Fields (Continued)
The Auto Term(J) parameter only has an effect when the
II
key is pressed in block mode.
AutoTerm(J)
•
YES
Insert a non-displaying terminator at the current cursor position and then move the cursor
backward
to
the
previous displaying or non-displaying terminator (if none is found, the cursor
moves back
to
the
"home"
position).
AutoTerm(J)
•
NO
Do NOT insert a non-displaying terminator and do NOT
movE!.
the cursor backward.
CleerTerm(K)
•
YES
If the display transfer operation is terminated by encountering a non-displaying terminator, clear
the
terminator.
ClearTerm(K)
=
NO
Do NOT clear any non-displaying terminators.
Defaults: Auto Term(J) •
NO
CleerTerm(K) •
NO
This field is the
functional
equivalent of keyboard interface strap L on an
HP
2645 terminal.
YES
• The Power-On
Test,
Terminal
Test,
and Manufacturing
Test
are enabled (refer
to
section
IX
of
this
manual).
NO
• The Power-On
Test,
Terminal
Test,
and Manufacturing
Test
are all disabled. Any attempt
to
initiate these tests (including an
<ESC)z
sequence) results in
the
"FUNCTION
LOCKED"
error
message;
the
terminal operator clears the message by pressing
_.
The data comm self-
test is
not
affected by
this
field.
Default:
NO
This field is the functional equivalent
of
keyboard interface strap N on an
HP
2645 terminal.
YES
• When transferring data between display memory and an external printer, escape sequences
relating
to
the display (such as those specifying display enhancements, format mode fields,
and alternate character sets) are sent
to
the external printer
if
encountered within the
data.
NO
• Escape sequences relating
to
the
display are
not
sent
to
the external printer.
Default:
NO
This field is the functional equivalent
of
keyboard interface strap
Won
an
HP
2645 terminal.
YES
= The data comm self-test is enabled (refer
to
section
IX
of
this manual).
NO
• The data comm self-test is disabled. Pressing
the"
DATACOMMTEST"
(m)
function key (in the
"5ervice
keY5"set) or issuing an
<ESC)x
results
in
the
"FUNCTION
LOCKED"
error message; the
terminal operator clears
the
message by pressing
_.
Default:
NO
When
yOu
press the
II
key while
the
terminal is in
block
page mode and display memory contains
a formatted
display,
the
terminal automatically transmits the specified field separator character at
the end
of
each unprotected field (except the final one).
Value: Any ASCII character
Default:
<US)
2-7
To Next Page
Loading...
Need help?
General
