HP 2624 User Manual

Status
DEVICE STATUS
The status of the integral printer or an external printer
can be obtained by issuing a device status request. This
request would typically be made following a print opera-
tion or after examining bytes 5 and 6 of the terminal
status. The device status bytes are shown on page 8-7.
You request device status by issuing the following escape
sequence:
<ESC)&p <device code)"
where <device code) is either 4 or 6. Unless device code 4
COMPUTER
ESC & p6 1\ OCt
•
..
ESC \ p6 081 CR
8yte 0 J L
ayte
2
BYTE
ASCII
BINARY
has been redefined by way of the Terminal Configuration
menu,
the two codes are interpreted as follows:
4 = external printer
6 = integral printer
If<device code) is any value other than 4 or 6, the escape
sequence is ignored.
The terminal responds with the sequence <ESC)\p<device
code) followed by three status bytes followed by a ter-
minator. A typical device
status request and response are
illustrated in figure 8-3.
TERMINAL
PRINTER
STATUS
0 0
-- No print 'error
8
"1
000
Last print command performed
2 -- Printer is on-line
Figure 8-3. Device Status Example
8-6
(
(
(

HP 2624 Specifications

General

Brand	HP
Model	2624
Category	Touch terminals
Language	English