HP 3600 v2 Series Configuration Guide

95
802.1X MAC address binding entries never age out. They can survive a user logoff or a device reboot.
To delete an entry, you must use the undo dot1x binding-mac mac-address command.
After the number of 802.1X MAC address binding entries reaches the upper limit of concurrent 802.1X
users, the following restrictions exist:
• Users not in the binding entries will fail authentication even after users in the binding entries go
offline.
• New 802.1X MAC address binding entries are not allowed.
When you configure the 802.1X MAC address binding feature on a port, follow these restrictions and
guidelines:
• The 802.1X MAC address binding feature takes effect only when the port performs MAC-based
access control.
• Manually configured MAC address binding entries take effect only when the 802.1X MAC address
binding feature takes effect.
• An 802.1X MAC address binding entry cannot be deleted when the user in the entry is online.
To configure the 802.1X MAC address binding feature on a port:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type interface-number N/A
3. Enable the 802.1X
MAC address
binding feature.
dot1x binding-mac enable
By default, the feature is
disabled.
4. Manually configure
802.1X MAC address
binding entries.
dot1x binding-mac mac-address
Optional.
By default, no 802.1X
MAC address binding
entries are configured on
the port.
Displaying and maintaining 802.1X
Task Command Remarks
Display 802.1X session
information, statistics, or
configuration information of
specified or all ports.
display dot1x [ sessions | statistics ]
[ interface interface-list ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Clear 802.1X statistics. reset dot1x statistics [ interface interface-list ] Available in user view

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English