EasyManuals Logo
Home>HP>Switch>3600 v2 Series

HP 3600 v2 Series Configuration Guide

HP 3600 v2 Series
449 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
143
Configuring an authentication source subnet
Only Layer 3 portal authentication supports this feature.
By configuring authentication source subnets, you specify that only HTTP packets from users on the
authentication source subnets can trigger portal authentication. If an unauthenticated user is not on any
authentication source subnet, the access device discards all the user's HTTP packets that do not match
any portal-free rule.
To configure an authentication source subnet:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an authentication
source subnet.
portal auth-network
{ ipv4-network-address
{ mask-length | mask } | ipv6
ipv6-network-address
prefix
-length }
Optional.
By default, the source IPv4 subnet
is 0.0.0.0/0, and the source IPv6
subnet is ::/0, meaning that users
from any IPv4 or IPv6 subnet must
pass portal authentication to
access network resources.
You can configure multiple
authentication source subnets by
executing the portal auth-network
command repeatedly.
NOTE:
Configuration of authentication source subnets applies to only cross-subnet authentication. In direct
authentication mode, the authentication source subnet is 0.0.0.0/0. In re-DHCP authentication mode, the
authentication source subnet of an interface is the subnet to which the private IP address of the interface
belongs.
Setting the maximum number of online portal users
You can use this feature to control the total number of online portal users in the system.
If the maximum number of online portal users to be set is less than that of the current online portal users,
the limit can be set successfully and does not impact the online portal users, but the system does not allow
new portal users to log on until the number drops down below the limit.
To set the maximum number of online portal users allowed in the system:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Set the maximum number of
online portal users.
portal max-user max-number 1024 by default.

Table of Contents

Other manuals for HP 3600 v2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3600 v2 Series and is the answer not in the manual?

HP 3600 v2 Series Specifications

General IconGeneral
BrandHP
Model3600 v2 Series
CategorySwitch
LanguageEnglish

Related product manuals