HP 3600 v2 Series Configuration Guide

202
To set the maximum number of secure MAC addresses allowed on a port:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Set the limit of port security on
the number of MAC
addresses.
port-security max-mac-count
count-value
Not limited by default.
Setting the port security mode
After enabling port security, you can change the port security mode of a port only when the port is
operating in noRestrictions (the default) mode. To change the port security mode for a port in any other
mode, first use the undo port-security port-mode command to restore the default port security mode.
You can specify a port security mode when port security is disabled, but your configuration cannot take
effect.
You cannot change the port security mode of a port when online users are present.
Configuration prerequisites
Before you set a port security mode for a port, complete the following tasks:
• Disable 802.1X and MAC authentication.
• Verify that the port does not belong to any aggregation group or service loopback group.
• If you are configuring the autoLearn mode, set port security's limit on the number of MAC addresses.
You cannot change the setting when the port is operating in autoLearn mode.
Configuration procedure
To enable a port security mode:
Step Command Remarks
1. Enter system view. system-view N/A
2. Set an OUI value for
user authentication.
port-security oui oui-value index
index-value
Required for the userlogin-withoui
mode.
Not configured by default.
To set multiple OUI values, repeat this
step.
3. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English