HP 3600 v2 Series

406
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Enable periodic gateway
probe.
mac-forced-forwarding gateway
probe
Disabled by default.
Specifying the IP addresses of servers
You need to maintain a server list on the MFF device. The list contains the IP addresses of servers in the
network to ensure communication between the servers and clients.
You can specify a server's IP address in either manual or automatic MFF mode. The server can be a
DHCP server, a server providing some other service, or the real IP address of a VRRP standby group. After
you specify a server's IP address and then an ARP request from the server is received, the MFF device will
search the IP-to-MAC address entries it has stored, and reply with the corresponding MAC address to the
server. As a result, packets from a host to a server are forwarded by the gateway, but packets from a
server to a host are not forwarded by the gateway.
To specify the IP addresses of servers:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Specify the IP addresses of
servers.
mac-forced-forwarding server
server-ip&<1-10>
No server IP address is specified by
default.
Displaying and maintaining MFF
Task Command Remarks
Display MFF port configuration
information.
display mac-forced-forwarding interface [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display the MFF configuration
information of a specified VLAN.
display mac-forced-forwarding vlan vlan-id
[ | { begin | exclude | include }
regular-expression ]
Available in any view