HP 3600 v2 Series Configuration Guide

175
[SwitchB-radius-rs1] key accounting simple expert
# Configure the access device to not carry the ISP domain name in the username sent to the
RADIUS server. (Optional, configure the username format as needed.)
[SwitchB-radius-rs1] user-name-format without-domain
[SwitchB-radius-rs1] quit
3. Configure an authentication domain:
# Create ISP domain dm1 and enter its view.
[SwitchB] domain dm1
# Configure AAA methods for the ISP domain.
[SwitchB-isp-dm1] authentication portal radius-scheme rs1
[SwitchB-isp-dm1] authorization portal radius-scheme rs1
[SwitchB-isp-dm1] accounting portal radius-scheme rs1
[SwitchB-isp-dm1] quit
# Configure domain dm1 as the default ISP domain for all users. Then, if a user enters a username
without any ISP domain at logon, the authentication and accounting methods of the default
domain are used for the user.
[SwitchB] domain default enable dm1
4. Enable portal authentication on the interface connecting the host:
# Configure the portal server as needed.
[SwitchB] portal server newpt ip 192.168.0.111 key simple portal port 50100 url
http://192.168.0.111:8080/portal
# Enable portal authentication on the interface connecting the host.
[SwitchB] interface vlan-interface 10
[SwitchB–Vlan-interface10] portal server newpt method layer3
# Specify the source IP address of outgoing portal packets as 9.9.1.1, the virtual IP address of
VRRP group 1.
[SwitchA–Vlan-interface10] portal nas-ip 9.9.1.1
5. Configure portal stateful failover:
# Assign interface VLAN-interface 10 to portal group 1.
[SwitchB–Vlan-interface10] portal backup-group 1
[SwitchB–Vlan-interface10] quit
# Set the ID of the device in the stateful failover mode to 2.
[SwitchB] nas device-id 2
# Specify the source IP address of outgoing RADIUS packets as 192.168.0.1, the virtual IP
address of VRRP group 2.
[SwitchB] radius nas-backup-ip 192.168.0.1
Make sure you have added the access device with IP address 192.168.0.1 on the RADIUS server.
6. Configure stateful failure:
# Configure the VLAN for stateful failover as VLAN 8.
[SwitchB] dhbk vlan 8
# Enable stateful failover and configure it to support the symmetric path.
[SwitchB] dhbk enable backup-type symmetric-path

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English