EasyManuals Logo
Home>HP>Switch>3600 v2 Series

HP 3600 v2 Series Configuration Guide

HP 3600 v2 Series
449 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #309 background imageLoading...
Page #309 background image
296
• Specify the dead peer detection (DPD) detector for the IKE peer.
To configure an IKE peer:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an IKE peer and enter
IKE peer view.
ike peer peer-name N/A
3. Specify the IKE negotiation
mode for phase 1.
exchange-mode main
Optional.
The default is main.
4. Specify the IKE proposals for
the IKE peer to reference.
proposal proposal-number&<1-6>
Optional.
By default, an IKE peer references
no IKE proposals, and, when
initiating IKE negotiation, it uses
the IKE proposals configured in
system view.
5. Configure the pre-shared key
for pre-shared key
authentication.
pre-shared-key [ cipher key ]
Configure either command
according to the authentication
method for the IKE proposal.
6. Configure the PKI domain for
digital signature
authentication.
certificate domain domain-name
7. Select the ID type for IKE
negotiation phase 1.
id-type { ip | name | user-fqdn }
Optional.
ip by default.
8. Configure the names of the
two ends.
• Specify a name for the local
security gateway:
local-name name
• Configure the name of the
remote security gateway:
remote-name name
Optional.
By default, no name is configured
for the local security gateway in
IKE peer view, and the security
gateway name configured by
using the ike local-name
command is used.
The remote gateway name
configured with remote-name
command on the local gateway
must be identical to the local
name configured with the
local-name command on the
peer.
9. Configure the IP addresses of
the two ends.
• Specify an IP address for the
local gateway:
local-address ip-address
• Configure the IP addresses of the
remote gateway:
remote-address { hostname
[ dynamic ] | low-ip-address
[ high-ip-address ] }
Optional.
By default, it is the primary IP
address of the interface
referencing the security policy.
The remote IP address configured
with the remote-address
command on the local gateway
must be identical to the local IP
address configured with the
local-address command on the
peer.

Table of Contents

Other manuals for HP 3600 v2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3600 v2 Series and is the answer not in the manual?

HP 3600 v2 Series Specifications

General IconGeneral
BrandHP
Model3600 v2 Series
CategorySwitch
LanguageEnglish

Related product manuals