HP 5920 Series Fundamentals Configuration Guide

36
Figure 13 Dialing the number
8. After you hear the dial tone, press Enter as prompted.
If the authentication mode is none, the prompt <HP> appears. If the authentication mode is
password or scheme, you must enter the correct authentication information as prompted.
Figure 14 Login page
IMPORTANT:
Do not directly close the HyperTerminal. Doing so can cause some modems to stay in use, and your
subsequent dial-in attempts will always fail.
To disconnect the PC from the device, execute the appropriate ATH command in the HyperTerminal. If the
command cannot be entered, type AT+ + + and press Enter, and when the word OK appears, execute the
ATH command. The connection is terminated if OK is displayed. You can also terminate the connection
by clicking in the HyperTerminal window.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English