EasyManuals Logo

HP 5920 Series Fc And Fcoe Configuration Guide

HP 5920 Series
257 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #123 background imageLoading...
Page #123 background image
116
Requirements analysis
To meet the network requirements, divide VSAN 1 into three zones as follows:
• Assign Server A to Zone 1.
• Assign Server B and Disks A, B, and C to Zone 2.
• Assign Server C and Disks B and C to Zone 3.
• Enable Pairwise for Zone 2, configure Server B as an initiator, and configure Disks A, B, and C as
targets.
• Enable Pairwise for Zone 3, configure Server C as an initiator, and configure Disks B and C as
targets.
• Create zone alias Alias 1, which contains Disks B and C, to simplify the configuration.
• Create zone set Zoneset 1, which contains Zones 1, 2, and 3, and activate it.
Configuration procedure
This section describes only FC zone configurations on Switch A. You do not need to configure FC zones
on Switch B.
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
<SwitchA> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
# Enable the enhanced zoning mode in VSAN 1.
[SwitchA] vsan 1
[SwitchA-vsan1] zone mode enhanced

Table of Contents

Other manuals for HP 5920 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5920 Series and is the answer not in the manual?

HP 5920 Series Specifications

General IconGeneral
BrandHP
Model5920 Series
CategorySwitch
LanguageEnglish

Related product manuals