HP 5920 Series Fc And Fcoe Configuration Guide

57
Configuring fabric timers
The fabric operation involves the following timers:
• Distributed service timeout period.
• Error detection timeout period.
• Resource allocation timeout period.
For more information about these timers, see FC-related protocols and standards.
You can configure fabric timers in one of the following views:
• System view—The configuration takes effect on all VSANs.
• VSAN view—The configuration takes effect only on the VSAN.
If you configure a fabric timer in both system view and VSAN view, the configuration in VSAN view
applies to the VSAN.
Configuring fabric timers in system view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the global
distributed service timeout
period.
fc timer distributed-services value
The default setting is 5000
milliseconds.
3. Configure the global error
detection timeout period.
fc timer error-detect value
The default setting is 2000
milliseconds.
4. Configure the global
resource allocation timeout
period.
fc timer resource-allocation value
The default setting is 10000
milliseconds.
Configuring fabric timers in VSAN view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSAN view.
vsan vsan-id N/A
3. Configure the distributed
service timeout period for
the VSAN.
timer distributed-services value
The default setting is 5000
milliseconds.
4. Configure the error
detection timeout period
for the VSAN.
timer error-detect value
The default setting is 2000
milliseconds.
5. Configure the resource
allocation timeout period
for the VSAN.
timer resource-allocation value
The default setting is 10000
milliseconds.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English