HP 5920 Series - Configuration Procedure; Configuring FSPF; FSPF Configuration Task List; Enabling FSPF

74
Configuration procedure
To configure a static FC route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSAN view.
vsan vsan-id N/A
3. Configure a static FC
route.
fc route-static fcid { mask | mask-length }
interface-type interface-number [ cost
cost-value ]
By default, no static FC route exists.
Configuring FSPF
FSPF is enabled by default. Typically, you do not need to perform special operations.
You can change FSPF parameters on a per-VSAN or per-interface basis.
FSPF configuration task list
Tasks at a
g
lance
Change FSPF parameters for a VSAN in VSAN view
• (Required.) Enabling FSPF
• (Optional.) Configuring the shortest SPF calculation interval
• (Optional.) Configuring the minimum LSR arrival interval
• (Optional.) Configuring the minimum LSR refresh interval
(Optional.) Change FSPF parameters for an interface in E_Port interface view
• Configuring the FSPF cost for an interface
• Configuring the hello interval for an interface
• Configuring the dead interval for an interface
• Configuring the LSR retransmission interval for an interface
• Disabling FSPF for an interface
(Optional.) Configuring FSPF GR
• Configuring the GR restarter
• Configuring the GR helper
Enabling FSPF
FSPF-related features can work in a VSAN only after you enable FSPF for the VSAN.
To enable FSPF:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A