HP 5920 Series Fc And Fcoe Configuration Guide

79
Task Command
Display FC FIB table information. display fc fib [ fcid [ mask-length ] ] vsan vsan-id
Display FC Exchange table information.
display fc exchange { link | protocol } [ slot slot-number ]
display fc exchange link verbose [ slot slot-number [ exid
exid ] ]
Display FSPF neighbor information. display fspf neighbor [ vsan vsan-id ]
Display link state database information. display fspf lsdb [ vsan vsan-id ]
Display FSPF GR state information. display fspf graceful-restart [ vsan vsan-id ]
Display FSPF statistics. display fspf statistics [ vsan vsan-id ]
Clear FSPF statistics. reset fspf counters [ vsan vsan-id ]
FC routing configuration examples
Static FC routing configuration example by using FC interfaces
Network requirements
As shown in Figure 27, configure static routes to enable any two FC switches to communicate with each
other.
Figure 27 Network diagram
Configuration procedure
This section describes only FC routing configurations.
1. Configure Switch A:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
Switch B
Switch A
FC1/0/1
XGE1/0/1
Switch C
Domain ID: 1 Domain ID: 3
Domain ID: 2
FC1/0/1
XGE1/0/1
FC1/0/2
XGE1/0/2
FC1/0/2
XGE1/0/2

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English