HP 5920 Series - NPV Configuration Example by Using VFC Interfaces

127
[SwitchB-Fc1/0/3] quit
# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.
[SwitchB] vlan 10
[SwitchB-vlan10] fcoe enable vsan 1
[SwitchB-vlan10] quit
Verifying the configuration
# Display the nodes on downlink interfaces and their mapped uplink interfaces.
[SwitchA] display npv login
Server External
Interface VSAN FCID Node WWN Port WWN Interface
Fc1/0/1 1 0x010001 20:00:00:00:c8:00:e4:30 21:00:00:00:c8:60:e4:9a Fc1/0/3
Fc1/0/2 1 0x010002 20:00:00:00:c9:00:e4:30 21:00:00:00:c9:60:e4:9a Fc1/0/3
# Display information about uplink and downlink interfaces on Switch A.
[SwitchA] display npv status
External Interfaces:
Interface: Fc1/0/3 VSAN tagging mode: Non Tagging
VSAN State FCID
1 Up 0x010000
Number of External Interfaces: 1
Server Interfaces:
Interface : Fc1/0/1 VSAN tagging mode: Non Tagging
VSAN State
1 Up
Interface : fc1/0/2 VSAN tagging mode: Non Tagging
VSAN State
1 Up
Number of Server Interfaces: 2
# Display the traffic mapping information on the NPV switch Switch A.
[SwitchA] display npv traffic-map
NPV traffic map information of VSAN 1:
Server Interface External Interface
Fc1/0/1 Fc1/0/3
Fc1/0/2 Fc1/0/3
NPV configuration example by using VFC interfaces
Network requirements
As shown in Figure 38, configure the edge switch (Switch A) as an NPV switch to expand the network.