HP 5920 Series Fc And Fcoe Configuration Guide

76
Ste
p
Command Remarks
2. Enter VSAN view.
vsan vsan-id N/A
3. Configure the minimum
LSR refresh interval.
fspf min-ls-interval value The default setting is 5 seconds.
Configuring the FSPF cost for an interface
Each link has a cost. The route selection algorithm uses this value to determine the best route. The smaller
the interface FSPF cost, the smaller the link cost.
To configure the FSPF cost for an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter FC interface, FC
aggregate interface, or
VFC interface view.
interface { fc | vfc |
san-aggregation }
interface-number
N/A
3. Configure the FSPF cost
for the interface in a
specific VSAN.
fspf cost value vsan vsan-id
The default setting of FC interfaces is
calculated by using the following formula:
1.0*1.062e12/baud rate.
The default setting for VFC interfaces and FC
aggregate interfaces are 100.
Configuring the hello interval for an interface
The hello interval specifies the time between the hello packets sent periodically by the switch to discover
and maintain neighbor relationships.
NOTE:
The configured hello interval must be smaller than the dead interval and must be the same at the two ends
of the link.
To configure the hello interval for an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter FC interface, FC
aggregate interface, or VFC
interface view.
interface { fc | vfc |
san-aggregation }
interface-number
N/A
3. Configure the hello interval for
the interface in a specific VSAN.
fspf hello-interval value vsan
vsan-id
The default setting is 20 seconds.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English