125
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
<SwitchA> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in NPV mode.
<SwitchA> system-view
[SwitchA] fcoe-mode npv
# Create VSAN 1.
[SwitchA] vsan 1
[SwitchA-vsan1] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/3 into FC interface FC 1/0/3, which acts
as an uplink port.
[SwitchA] interface ten-gigabitethernet 1/0/3
[SwitchA-Ten-GigabitEthernet1/0/3] port-type fc
# Configure the mode of interface FC 1/0/3 as NP.
[SwitchA-Fc1/0/3] fc mode np
# Configure interface FC 1/0/3 to autonegotiate the speed.
[SwitchA-Fc1/0/3] speed auto
# Configure the trunk mode of interface FC 1/0/3 as On, and assign interface FC 1/0/3 to
VSAN 1 as a trunk port.
[SwitchA-Fc1/0/3] port trunk mode on
[SwitchA-Fc1/0/3] port trunk vsan 1
[SwitchA-Fc1/0/3] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/1 into FC interface FC 1/0/1, which acts
as a downlink port.
[SwitchA] interface ten-gigabitethernet 1/0/1
[SwitchA-Ten-GigabitEthernet1/0/1] port-type fc
# Configure the mode of interface FC 1/0/1 as F.
[SwitchA-Fc1/0/1] fc mode f
# Configure interface FC 1/0/1 to autonegotiate the speed.
[SwitchA-Fc1/0/1] speed auto
# Assign FC interface FC 1/0/1 to VSAN 1 as an access port.
[SwitchA-Fc1/0/1] port access vsan 1
[SwitchA-Fc1/0/1] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/2 into FC interface FC 1/0/2, which acts
as a downlink port.
[SwitchA] interface ten-gigabitethernet 1/0/2
[SwitchA-Ten-GigabitEthernet1/0/2] port-type fc
# Configure the mode of interface FC 1/0/2 as F.
[SwitchA-Fc1/0/2] fc mode f
# Configure interface FC 1/0/2 to autonegotiate the speed.
[SwitchA-Fc1/0/2] speed auto
To Next Page
Loading...
