10
Contents
Chapter 4 Maintaining the MSD
Before starting 94
Maintaining the vacuum system 101
To check and add foreline pump oil, 102
To drain the foreline pump, 104
To refill the foreline pump, 106
To replace the oil trap, 108
To check the diffusion pump fluid, 110
To separate the MSD from the GC, 112
To remove the diffusion pump, 114
To replace the diffusion pump fluid, 116
To reinstall the diffusion pump, 118
To reconnect the MSD to the GC, 120
To remove the calibration vial, 122
To refill and reinstall the calibration vial, 124
To remove the foreline gauge, 126
To reinstall a foreline gauge, 128
To remove the calibration valve, 130
To reinstall a calibration valve, 132
To replace the fan for the high vacuum pump, 134
To remove the triode gauge tube, 136
To reinstall a triode gauge tube, 138
To lubricate the side plate O-ring, 140
To lubricate the vent valve O-ring, 142
Maintaining the analyzer 144
To remove the ion source, 146
To disassemble the ion source, 148
To clean the ion source, 150
To reassemble the ion source, 154
To reinstall the ion source, 156
To remove a filament, 158
To reinstall a filament, 160
To remove the heater and sensor from the ion source, 162
To reinstall the heater and sensor in the ion source, 164
To remove the heater and sensor from the mass filter, 166
To reinstall the heater and sensor in the mass filter, 168
To replace the electron multiplier horn, 170
To Next Page
Loading...
