FINAL TRIM SIZE : 7.0 in x 8.5 in
5
Note
SAM does not support the follo
wing:
Changing the hardware address of a disk driv
e containing
the ro ot le system.
Changing the hardware address of a disk array
.
Changing the hardware address of a disk that is part of
software disk striping.
After hardware installation has b een completed (see the
Instal lation Guide
for
this device), you'll need to ensure that your op erating system is prepared to
exchange data with the device. This section pro
vides instructions for doing
this.
1. Run SAM bytyping:
/usr/bin/sam
Pressing the
4
f1
5
key gives you context-sensitive information for the ob ject
at the lo cation of the cursor.
2. Cho ose
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Disks and File Systems
(highlight and clickon
4
OK
5
or press
4
Return
5
).
3.
Cho ose
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
CD-ROM, Floppy, and Hard Disks
.
4. Cho ose the line identifying the type of new disk you have connected. In the
\Use" column, it will b e designated as \unused".
DRAFT
2/5/97 11:31
Configuring HP-UX for Printers and Drives 5-11
To Next Page
Loading...
Need help?
General
