HP BladeSystem c7000 - Mapping to interconnect ports

Removal and replacement procedures 48
11.
Remove the rear cage ("Rear cage" on page 45).
WARNING: To reduce the risk of personal injury or equipment damage, at least two people are
needed to safely move the rear cage.
12. Remove the three T-15 Torx screws that secure the Insight Display cable center cover, and then remove
the cover.
13. Disconnect the Insight Display cable.
14. Remove the four T-15 Torx screws that secure the interconnect board cover, and then remove the cover.
NOTE: The device bay walls have been removed for clarity.