HP BladeSystem c7000 - HP Bladesystem Insight Display

Removal and replacement procedures 36
o
Half-height blade
o Full-height blade
CAUTION: For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component, replace it
with a blank.
To replace the component, reverse the removal procedure.
HP BladeSystem Insight Display
To remove the component:
1. Power down the enclosure (on page 29).
2. Remove the following components:
o Half-height blades: bays 9-13 ("Half-height or full-height blade" on page 34)