HP Codemaster 100 - Preparing the Leads for Monitoring; 3-Wire Patient Cable

0RQLWRULQJ
Using Leads to Monitor
5-3
Preparing the Leads for Monitoring
You can configure the HP CodeMaster 100 to use either a 3-wire, 5-wire, or
10-wire patient cable (with the 12-Lead option). Use the procedure as
described in Table 2-2 on page 2-12 to set up the patient cable type (3-wire, 5-
wire, 10-wire).
3-Wire Patient Cable
Table 5-2 describes typical lead-wire placement using the 3-wire patient
cable. Table 5-3 shows how the individual leads are formed using the
individual leadwires.
Table 5-2 3-Wire Electrode Placement
Electrode Placement
5$:K LW H 1HDUULJKWPLGFODYLFXODUOLQHGLUHFWO\EHORZWK HFODYLFOH
/$%ODFN 1HDUWKHOHIWPLGFO DYLFXODUOLQHGLUHFWO\EHORZ WKHFODYLFOH
//5HG %HORZ WKHOHIWSHFWRUDOPXVFO HRQWKHOHIWPLGFODYLFXODUOLQH
Table 5-3 Lead Formation
Lead + − ref
,/$5$//
,, // 5$ /$
,,, // /$ 5$