HP Codemaster 100 - Battery Capacity Test

0DLQWHQDQFH
CodeMaster 100
13-15
Battery Capacity Test
Perform a battery capacity test every 90 days or when the indicator
( ) flashes after you insert the battery pack into the battery support
system for charging.
1 Insert the battery into charging bay. The indicator appears
(the indicator may appear instead).
2 Press the start button( ). The indicator appears and the
(or ) indicator disappears. Testing the battery takes
approximately 24 hours.
Battery capacity testing is complete when the PASS indicator appears.
3 Record the date of the test on the bottom of the battery.
If the indicator appears, the battery did not pass the test. Remove
the battery from service immediately and notify service personnel.
The battery support system will automatically charge and recondition
batteries during the capacity test.
Dispose of equipment and accessories at the end of their useful life in
accordance with local and national laws.
START
CHARGING
READY
TESTING
CHARGING READY
WARNING
FAULT
NOTE
NOTE